Tools

This tool for fine,accurate,easy adjustments of camber or caster on GM vehicles. No extra parts or cutting/grinding needed. California Residents WARNINGInstallation InstructionsThis Part...

A must for proper alignments. This tool securely holds the steering wheel and it's covered hooks & base prevent damage to the steering wheel and seat.----------------------------- CAUTION: This product is not a locking device. Use only according to...

The 76000 Mercedes C & E Class Rear Bushing Press Adapter Kit is designed for quick, easy removal of the OE rear control arm bushings and for the installation of the new adjustable camber bushings. This is a necessary kit for installing SPC's 28850 &...

160ft. lbs.-Orange-1/2" drive extension for: 1999 & up Ford Super Duty trucks and 2000-2005 extensions. California Residents WARNINGInstallation Instructions

Product appearance and features may vary in the market as design changes, improvements and modifications are implemented.Installation Instructions

For Hunter Model # 201,205--- Hunter Part # V302-07-167--- 12 cut edges ---- negative rake 10 bits per pack. California Residents WARNING

Product appearance and features may vary in the market as design changes, improvements and modifications are implemented.

A handy chromoly steel compressor designed to fit inside most coil springs with an internally mounted shock. Will accomodate spring lengths from 8-1/4" to 14". It can be used on any coil spring with a minimum inside diameter of 3-3/8" to a maximum...

Stop damaging steering knuckles by removing linkages or struts with pry bars, screwdrivers and hammers. Use the Steering Knuckle Spreader Tool to make quick work of tight and corroded steering knuckles by simply turning the threaded wedge assembly...

Stop wheel hop and vibrations on hub piloted wheels! Hub pilot hole diameter tolerances can allow wheels to be installed and tightened in an "off-center" or clocked position. The 32115 is for Ford F450/550 Super Duty. These tools slide directly over...

For Pro-Cut Model 610 On-The-Car Lathe---- Pro-Cut Part # 50-701---- 3 cut edges ---- positive rake for Fords 10 bits per pack. California Residents WARNING

For Model #s 1000,1001,3000,4000,4100,7000,7700------- On-vehicle lathe 700,705,710------- Drum side on 3850------12-18 cut edges----round bits for round tool holders 10 bits per pack. California Residents WARNING

Product appearance and features may vary in the market as design changes, improvements and modifications are implemented.

Designed for the low-profile clamps used to hold C.V. Boots on FWD vehicles. The 02099 comes complete with a ratchet. We recommend using this tool when istalling our #87365 Crown victoria camber kit. California Residents WARNINGThis Part...

Ridetech CoolCap Recessing/Flange Tool